19
Image Vault
®
PRO Command
4 Initialization
Be sure to observe all cautions and warnings and other written requirements relating to installation. Test the equipment for proper
operation.
4.1
Positioning
Turn the DVR so that all cables and connections are to the rear of the unit and the front with the “Video Download to CD” button is
clearly viewable and accessible. The DVR has standard 4U rack mount brackets for easy installation in a standard 19 inch hardware rack.
4.2
Power
A dedicated NEMA 15 amp 115 V
AC
grounded outlet must be provided within 6 feet (2 m) of the DVR. The DVR may share its AC circuit
with other point of sale electronic equipment, but must not be on the same circuit as rotating machinery such as refrigeration
equipment or fuel pumps. Do not connect other loads to the DVR’s UPS (see warnings in Section 1.1).
Plug the power cord into the back of the DVR and the other end into the Uninterruptible Power Supply (UPS) battery backup electrical
receptacle. The DVR must be the only item using a battery backup receptacle on the UPS. Plug the UPS into the main AC outlet. The
UPS protects the DVR from power surges or dips and prevents shutdown during a brief power loss.
CAUTION: DO NOT TURN OFF
OR REBOOT DURING BOOT-UP PROCESS.
4.3
How to Check If the System is Working Properly
Turn on the power supply switch (next to the power cable input). Press the power button on the rear of the DVR to start the recorder.
Within moments of power-up, you should hear a series of beeps. The number of beeps will equal the number of cameras detected. If a
video monitor is connected to the public view monitor output(s), you should begin seeing video from the cameras, switching
approximately every four seconds or at a user-defi ned interval. If a VGA monitor is connected you will be able to watch the system
startup.
Wait a minimum of fi ve (5) minutes before attempting to connect to the system remotely. The DVR must begin capturing and storing
images in order to properly begin confi guring cameras.
At this point the DVR is operating properly and recording images. The system is operating with default settings that are
pre-programmed in the unit. Refer to PART II for software instructions to confi gure and monitor the unit.
Note: DVR’s shipped from the factory are shipped with the Time Zone set for PST.
4.4
CD-R or DVD-R Disk
Insert the blank CD-R or DVD-R disk into the CD/DVD-R drive on the front of the unit. Image Vault will perform the necessary disk
processing when it writes video or setup data to the disk.
4.5
Troubleshooting Installation
Verify connections and that all components appropriate have power. If everything appears connected correctly per Section 2, contact
your local Image Vault distributor or call Image Vault directly at 1.888.462.4382.
4.6
Hardware Specifi cations
Dimensions (typical):
19” (D) x 16 3/4” (W) x 7” (H)
Power:
115/230
V
AC
; 6/3 Amp; 60/50 Hz
Operating Temperature:
41 to 104°F (5 to 40°C)
Содержание PRO COMMAND
Страница 57: ...57 Image Vault PRO Command Notes...
