19
b. If the walking belt has shifted to the right, first remove the key
and
UNPLUG THE POWER CORD
. Using the allen wrench, turn
the left rear roller adjustment bolt counterclockwise, and the right
bolt clockwise, 1/4 of a turn each. Be careful not to overtighten
the walking belt. Plug in the power cord, insert the key and run
the treadmill for a few minutes. Repeat until the walking belt is
centered.
c. If the walking belt slips when walked on, first remove the key and
UNPLUG THE POWER CORD
. Using the allen wrench, turn both
rear roller adjustment bolts clockwise, 1/4 of a turn. When the
walking belt is correctly tightened, you should be able to lift each
side of the walking belt 3 to 4 inches off the walking platform. Be
careful to keep the walking belt centered. Plug in the power cord,
insert the key and carefully walk on the treadmill for a few min-
utes. Repeat until the walking belt is properly tightened.
5. SYMPTOM: THE HEART RATE MONITOR DOES NOT FUNCTION PROPERLY
a. If the heart rate monitor does not function properly, refer to HEART RATE MONITOR TROUBLE-
SHOOTING on page 6.
b. If the heart rate monitor still does not function properly, the battery should be
changed. To replace the battery, locate the battery cover on the back of the sen-
sor unit. Insert a coin into the slot in the cover and turn the cover counterclock-
wise to the ÒopenÓ position. Remove the cover.
Remove the old battery from the sensor unit. Insert a new
CR 2032 battery
,
making sure that the writing is on top. In addition, make sure that the rubber gas-
ket is in place in the sensor unit. Replace the battery cover and turn it to the
closed position.
6. SYMPTOM: AN ERROR CODE (E1, E20, E21, E22, E23, OR E24) APPEARS ON THE CONSOLE
a. If an error code appears, remove the key from the console, wait for a moment, and then reinsert it. If the
error code appears again, call our Customer Service Department. Do not use the treadmill until the problem
is corrected.
b
c
Battery
Rubber
Gasket
