ILX Lightwave LDX-32420, Руководство пользователя

Страница: 71 / 104

C O M M A N D R E F E R E N C E
LDX-32420 Device-Dependent Command Reference
54
LDX-32420
C H A P T E R
4

The LASer:ENABle:EVEnt command sets the status event enable register of the LASER
operations. These events are summarized in bit 2 of the status byte register.
The LASer:ENABle:EVEnt? query returns the value of the status event enable register of
the LASER operation.
Parameters An <nrf value> whose sum represents the bits that are enabled:
Notes The enable registers normally retain their values at power-up (as they were at power-
down) unless the power-on status clear flag is set true (for more information see the
*PSC definition, in the GPIB-IEEE488 specification).
Examples "LAS:ENAB:EVENT 136" - action: enables the LASER status event register so that the
Open circuit and Power limit events will be reported (in summarized form) to the status
byte (bit 2).
"LAS:ENAB:EVE?" - response: 1040, means that the Output on/off state change and
Interlock changed LASER events will be reported (in summarized form) to the status byte
register (bit 2).
LASer:ENABle:EVEnt <flags>
LASer:ENABle:EVEnt?
F
RONT
P
ANEL
R
EMOTE
1 LASER Current Limit 256 Output is shorted
2 LASER Voltage Limit 512 Output changed to be in/out of tolerance
4 N/A 1024 Output on/off state changed
8 Power limit 2048 New measurements taken
16 Interlock changed state 4096 N/A
32 N/A 8192 N/A
64 Compliance Voltage Limit 16384 N/A
128 Open circuit 32768 N/A