ILUMEN PID Box Mini, Руководство по установке

Страница: 7 / 11

Ilumen
7
Installation Manual Ilumen PID Box Mini v1.3
7 C
OMMISSIONING
7.1 C
HECK
Do a final check whether everything is properly mounted and connected (see 5 and 6 for
details):

The PV frames are all connected to the same earth as the earth pin of the Ilumen PID Box
Mini

The PV and inverter DC cables are correctly connected

Unused DC inputs and outputs are terminated with a corresponding sealing plug

The DC side of DC power supply is correctly connected
If all these points are installed correctly you can start up the Ilumen PID Box Mini.
7.2 S
TARTING UP THE
I
LUMEN
PID S
OLUTION
The Ilumen PID Box Mini can only apply the Ilumen PID Solution in an automatic mode. To start
up the Ilumen PID Box Mini, plug in the DC power supply into a standard EU outlet (This outlet
must be on at all times). Next see if the LED light on the Ilumen PID Box Mini starts burning.
After checking the system it will be switched on automatically.
When the Ilumen PID Box Mini is hooked up correctly to the inverter you will see the following
status LED readouts.

BLUE: device is switched on, is in standby mode, measures a voltage on the PV
wires

GREEN: device is switched on, is in standby mode, measures a current on the PV
wires

CYAN: BLUE & GREEN

RED: device is switched on and cures the PV system

It is normal for the LED to be out at the beginning and at the end of the night
After start-up you may turn the DC switch of the inverter back on, followed by the AC side of the
PV plant.
The config button can be used to reinitialize the PID Solution if needed.