ResMark 5000 High-Resolution
Section 2: Quick Start
400386 Operations Manual Rev A
Page 13
Tool-less Locking
Handle
Rotate PM to
Adjust Tilt
Step 6: Print Head Level and Tilt
Print Head Level
1. Slightly loosen the Slide Bracketry Screws shown in the diagram in “Step 5: Adjust Print Head to Substrate” on page 12.
2. When the print head is perpendicular to the substrate, tighten the Slide Bracketry Screws.
3. Observe the LED indicators on the rear top of the print head on the ink supply. The green LED should be illuminated, and if not, adjust the
bracketry up or down as needed.
4. The print head is calibrated to /-1.5°
Print Head Tilt
1. Loosen the tool-less handle on the side of the Printer
Module.
2. Rotate the Printer Module to an angle that creates
perpendicular print on the product.
3. Tighten the tool-less handle.
Maximum Print Head Tilt from Vertical When Viewed
from the Rear of the Print Head:
•
Clockwise Tilt: 85° (Printer Module disengages from
the Ink Supply Module at 90°)
•
Counterclockwise Tilt: 90°
Cleaning and priming features are effective up to ±15 °
Print Head Level
Print Head Not Level
85° MAX
90° MAX
Usable Tilt
