14
Basic installation and configuration
/Configuration of general parameters
NoTE
To identify a module, in the
liSt of
headend modUleS
table click on the
cell corresponding to the MAC address of
the module. The cell will change to a fluo-
rescent green colour and the
SynC
and
StatUS
control LEDs for the selected
module flash together.
b) Click on the magnifying glass icon of the
module to be named.
c) In the main window of the user interface
go to the
ConfigUration > ConfigUration menu.
d) Enter the name of the module in the
modUle name
field.
CAUTIoN
If the background of the field is red, this means that the data has been modified
but has not yet been saved. Before changing the window or tab, the modified
data must be saved (click on
Save
). Otherwise the modified data will be lost and
the headend will remain in the same state as before.
Configuration of general parameters
Permits the modification of the basic identification, network and access parameters and of
the headend firmware.
To access from the main menu, click on
maSter modUle > ConfigUration.
J
inStallation data:
F
model:
shows the name of the module
model.
F
Serial nUmber:
shows the hardware
identification code.
F
maC addreSS:
shows the number which
identifies the unit for network connection.
F
modUle name:
enter the module name.
F
loCation:
allows the name of the city in
which the unit is installed to be entered.
F
inStaller:
allows the name of the person installing the equipment to be entered.
F
ContaCt nUmber:
allows the phone number of the installing company to be
entered.
F
date of inStallation:
allows the date on which the unit is installed to be
entered.
F
maSter modUle:
click on the checkbox on the right to select the module as
master.
F
Save
: click on the button to save the changes.
STC-100
STC-100
