IKH XW016, Инструкция по эксплуатации

Страница: 22 / 28

7
Tool rest (Fig. 16-17)
1. The tool rest (1) can be used with or without the extension arm (2). (Figure 16)
2. To move the tool rest base (3), loosen the lock lever (4) and move the base to the right or left
and back or front. Tighten the lever (4) when the tool rest base is in desired position.
(Figure
16)
3. When using the extension arm (2), make the necessary adjustments using lock levers (5) and (6)
to position the tool rest.
(Figure 16)
4. Tighten all tool rest lever handles (4,5,6) and ensure there is adequate clearance between the
workpiece and the tool rest assembly before turning the lathe on.
(Figure 16)
5. The tool rest can also be repositioned to the extension bed for use on outboard turnings. (Figure
17)
IMPORTANT: Make sure the tool rest is adjusted to be as close to the workpiece as possible.
Rotate the workpiece by hand to check clearane before turning the lathe on.
MAINTENANCE
WARNING: For your own safety, turn the switch off and remove the plug from power source
outlet before maintaining or lubricating the lathe.
-
Frequently blow out dust accumulation inside the motor, housing and bed assembly.
- A coating of automobile-type wax applied to the bed will help keep the surface clean and the
movement of the tool rest and tailstock smooth.
- Periodic lubrication of the spring levers and other threaded parts will make these parts easier to
operate.