IKH XW016, Инструкция по эксплуатации

Страница: 21 / 28

6
3. To attach the extension bed (1) to the bed, align the bolt holes (2) with the threaded bed holes
(3). Put the lock washer (4) on the hex bolt (5). First finger tighten the hex bolt, then secure the
hex bolt with the hex key provided.
ADJUSTMENTS
Headstock (Fig. 9-10)
1. The headstock has 5 preset positions
-
0
°
setting for all spindle turning applications
- 60
°
/ 90
°
/ 120
°
for use when making faceplate turnings
- 180
°
for use for faceplate turnings when using the extension bed and tool rest
2. To set the headstock at desired position, you must first turn the head lock handle (1) until you
have completed at least one rotation.
(Figure 10)
3. Pull out the headstock release (2). Rotate the entire headstock clockwise to desired setting. The
headstock will be fixed in position when it clicks into one of the five preset settings. Tighten the
lock handle (1).
Figure 11
WARNING: Do not turn the headstock assembly more than 180
°
clockwise from the spindle
setting position or damage to the wiring may occur.
Figure 11 a) Do not turn the headstock assembly counterclockwise beyond this position.
Figure 11 b) Do not turn the headstock assembly clockwise beyond this position.
OPERATION
WARNING: Do not operate the wood lathe until it is completely assembled and adjusted ac-
cording to instructions.
Switch (Fig. 12)
1. To turn the lathe on, open the yellow switch box and move the switch to the ”on”-position.
2. To turn the lathe off, move the switch to the ”off”-position and close the yellow switch box.
3. Never leave the lathe unattended until it has come to a complete stop.
Speed control (Fig. 13-14)
1. The lathe motor must be running before you can use the speed control lever.
2. The speed control lever can be turned to one of ten fixed speeds. To set the speed, pull back on
the lever handle (1) and turn the handle to the next fixed speed. Use the index plate (2) to
choose the lathe speed.
(Figure 13)
3. Turn the lever clockwise to increase the speed and counterclockwise to decrease the speed.
4. You must move the speed control lever to the lowest speed setting before turning the
switch off (Fig. 14), otherwise the motor may not start.
Tailstock (Fig. 15)
1. Move the tailstock (1) by loosening the lock lever (2) and pushing the tailstock to desired posi-
tion on the bed. Lock by tightening the lock lever (2).
2. The spindle can extend up to 63,5 mm (2 ½”) from the tailstock housing. You can move the
tailstock spindle (3) by loosening the spindle lock lever (4) and then turning the hand wheel (5).
Lock levers (4) and (2) before operating the lathe.
3. The tailstock spindle is hollow and can be accessed from the hand wheel end. Use the push-out
rod to remove the center cup.