IKH XW016, Инструкция по эксплуатации

Страница: 19 / 28

10
18. Hang your turning tools on the wall beyond the tailstock end of the lathe. Do not lay them on
such place that you must reach over the revolving workpiece to select them.
19. Keep a firm hold and remain in control of the cutting tool at all times. Take special precautions
when shaping a section of stock in which knots or voids are found.
20. Always make safety come first.
21. Complete the hand-sanding of all workpieces BEFORE you remove them from the lathe.
UNPACKING AND CHECKING THE CONTENT
Package content (Fig. 1)
a) Lathe bed assembly
b) Extension bed with hex bolts and washers
c) Faceplate
d) Spindle handle with spring and screw
e) Instruction
manual
f) Headstock spur center
g) Push-out
rod
h) 32 pcs nuts
i)
24 pcs washers
j) 5 pcs lock washers
k) 4 pcs hex keys 3, 4, 6, 8 mm
l)
Tailstock cup center
m) 2 pcs wrenches 32 mm
n) 24 pcs carriage bolts
o) 8 pcs hex bolts
p) 2 pcs long leg supports
q) 2 pcs front legs and 2 pcs rear legs
r) 2 pcs top leg plates
s) 2 pcs short leg supports
If some parts are missing, please contact your dealer or the importer.
PARTS
headstock
on/off-switch
tool rest base
bed
base lock lever
headstock
release
extension bed
head lock
motor
tool rest arm
spur center
headstock spindle speed control tool rest
tool rest lock lever
arm lock lever
cup center
tailstock spindle
hand wheel
tailstock
legs
spindle lock
tailstock lock
faceplate
wrenches
push-out rod