IKH AWD3855, Инструкция по эксплуатации

Страница: 21 / 29

For normal self-recovery work, your vehicle’s existing electrical system is adequate. A fully charged battery
and proper connections are essential. Run the vehicle engine during winching operations to keep battery
charged.
Pay close attention to proper electrical cable connection as follows (refer to Diagram 1)
1.
Short Red cable connects to the red terminal of the motor.
2.
Short black cable with yellow jacket connects to the yellow terminal of the motor.
3.
Short black cable with black jacket connects to the black terminal of the motor.
4.
Thin black cable connects to bottom terminal of the motor.
5.
Long Black Cable (1.83 m), one terminal connects to the bottom terminal of the motor, and the other
terminal negative (-) connects to negative (-) terminal of battery. Black cable in the diagram.
6.
Long red cable positive (+) connects to positive (+) terminal of battery.
Kaavio 1. Johdotusohjeet Kaavio 2. Virtajärjestelmän periaate
NOTE:
1.
Your battery must be kept in good condition.
2.
Be sure battery cables are not drawn across any surfaces, which could possibly damage them.
3.
Corrosion on electrical connections will reduce performance or may cause a short.
4.
Clean all connections especially in remote control switch and receptacle.
5.
Use a silicone sealer to protect from corrosion in marine environments.
6.
Index the heads of the plate studs into the keyhole slots on the back of the winch.
7.
Attach the winch/adaptor plate assembly to your trailer hitch by inserting the trailer hitch ball through
the receiver in the adaptor plate.
OPERATING YOUR WINCH
Read the following carefully before attempting to operate your winch and keep the instructions for future
reference.
1.
The uneven spooling of cable while pulling a load is not a problem unless there is a cable pile up on
one end of the drum. If this happens, reverse the winch to relieve the load and move your anchor point
further to the center of the vehicle. After the job is done you can un-spool and rewind for a neat lay of
the cable.
2.
Store the remote control switch inside your vehicle where it will not become damaged and inspect
before you plug it in.
3.
When ready to begin spooling in, plug in remote control switch with clutch disengaged. Do not engage
clutch with motor running.
4.
Never connect the hook back to the cable; this causes cable damage. Always use a sling or chain of
suitable strength.
21