IKH AWD3855, Инструкция по эксплуатации

Страница: 20 / 29

LUBRICATION
All moving parts in the winch are permanently lubricated with high temperature lithium grease at the time of
assembly. Under normal conditions factory lubrication will suffice. Lubricate cable periodically using light
penetrating oil. Inspect for broken strands and replace if necessary. If the cable becomes worn or damaged, it
must be replaced.
PREPARING THE CABLE FOR INSTALLATION
Unwind the new cable by rolling it along the ground to prevent kinking. Remove old cable and observe the
manner in which it is attached to the drum flange.
MOUNTING THE CONTROL BOX
The control box can be mounted in various ways depending on the application. What follows are the
manufacturer’s recommendations, which shows the steps to attach the control box to the winch motor
base.
WINCH WIRING INSTALLATION
CAUTION: When attaching wires to the motor or solenoid terminals, hold the inner nut with a wrench while
tightening the outer nut with a second wrench. Do not allow the terminals to rotate in their housings. Rotation
may cause internal wire damage or part misalignment.
20