Port Lock
IKELITE
Port Lock
IKELITE
11
12
Diagram H
NOTE:
If the attachment holes are facing toward the front of the housing, the tray must be removed
and re-attached to the housing so the attachment holes are facing toward the back of the housing.
This will allow for clearance of the 8” Dome Port once the Battery Pack is attached to the tray. You
may need to remove and rotate each handle so that the finger grips are facing toward the front of
the housing. To rotate each handle, remove the wingnut, 3/8” washer, and 9/16” thin nut. Rotate
handle 180 degrees and re-tighten to tray. Replace washer and wingnut.
3. Remove Battery Pack from Battery Pack Pouch.
4. Insert the 1/4-20 x 5/8” screws into the Mounting Plate so the screw heads are flush with the
textured side of the Plate.
5. Insert Plate with Screws into the Battery Pouch. Screws will protrude through Pouch holes
opposite the Ikelite logo.
6. Position Pouch so that the flap is facing towards back of housing.
7. Slide a phillips screwdriver through the logo side pouch holes and tighten both screws into Tray
Attachment Holes.
8. Insert Battery Pack into Pouch so that the Female Connectors face toward the back of the
housing. Close Flap over the Female Connectors.
-
If using two Battery Packs, see
Page 7
.
Attach Battery Pack to DSLR Housing (cont.)
Align back of tray with
back of housing front
Battery Pack
attachment holes
Battery Pack Tray
Mounting Screws
Battery Pack
Pouch Flap
Battery Pack Pouch
Cord End
Housing
Tray
Attach PRO-2800 to DSLR Housing
1. Place the Shoulder Washer on the Screw with the beveled edge
against the Screw Head.
2. Drop the 1/4-20 x 7/8” screw with Shoulder Washer into the top of
the Flex Mount.
3. Using a flathead screwdriver, attach the Flex Mount to the Top
Mount of the Ikelite DSLR housing.
4. Press desired number of pop-beads into PRO-2800 Lite Head
base to achieve desired height of Lite Head above housing.
5. Push Flex arm onto Flex Mount.
6. Attach Power Cord to Battery Pack and PRO-2800 Lite Head.
Either Cord End can be used for a component.
1/4-20 x 7/8”
Screw and
Shoulder Washer
Flex Mount
#0480
Flex Arm
pop-beads
PRO-2800
Lite Head
Ikelite DSLR
Housing
Attaching the PRO-2800 Lite Head and Flex Arm to Top Mount
1/4-20 x 7/8”
Screw
1” Ball Mount
#9571.6
(optional)
PRO-2800
Lite Head
Ikelite DSLR
Housing
Optional Stem
Mount #9573.3
Connects to Quick
Release Handle
Connects to Flex Arm
-
Optional 1” Ball #9571.6 is needed to attach the SA-100
Ball Socket Arm to the DSLR Top Mount -
Diagram I
.
-
Optional Stem Mount #9573.3 is needed to attach a Flex Arm to a
DSLR Quick Release Handle -
Diagram J
.
Diagram I
Diagram J
Female Connector
with Waterproof Cap
Female Connector with
Waterproof Cap removed
