9
10
Attach Battery Pack to Video Housing
Tray Setup and Battery Pack Attachment (Diagrams E, F & G)
1. Rotate base toggle and remove base from tray.
2. Place a video tray Mounting Nut into the video tray slot from the handle side of the tray. Slide
the round end to the round end of the tray slot.
3. Flip the tray over holding the mounting nut in the tray slot. Push an E-clip into the Mounting
Nut groove. The use of needle nose pliers may assist you in properly seating the E-clip:
Diagrams E, F & G.
4. Repeat the process with the remaining Mounting Nut and E-clip.
5. Re-attach the tray to the housing. Leave housing upside down.
6. Remove Battery Pack from Battery Pack Pouch.
7. Insert the longer 1/4-20 x 1” screws into the Mounting Plate so the screw heads are flush with
the textured side of the Plate.
8. Insert Plate with Screws into the Battery Pouch. Screws will protrude through Pouch holes
opposite the Ikelite logo.
9. Position Pouch so that the flap is facing towards back of housing.
10. Slide a phillips screwdriver through the logo side pouch holes and tighten both screws into
Mounting Nuts.
11. Insert Battery Pack into Pouch so that the Female Connectors face toward the back of the
housing. Close Flap over the Bulkheads.
12. Remove one Female Connector Cap and attach either end of the Power Cord. Hand tighten
only.
-
If using two Battery Packs, see
Page 7
.
Mounting Plate
Mounting Screws
Battery Pack
Pouch Flap
Battery Pack
Pouch
Power Cord
Video Tray
and Handles
“back view”
E-Clip
Mounting Nuts
Diagram F
Diagram E
Diagram G
1. When using the
SA-100 ball socket arm
, slide arm mount and 3/8” washer over handle stud,
tighten Wingnut.
2. Attach one Cord End to the Battery Pack and the other to the PRO-2800. Either Cord End can
be used for a component.
3. When using the
Flex Arm
, slide the Ball Mount over handle stud and hand tighten with the
Knurled Nut. It is not necessary to use any tools such as pliers to tighten the ring as this could
result in stripping of the Nut threads.
4. Grab the base of the Flex Arm with the PRO-2800 attached and push it onto the Ball Mount to
secure it to the handle. Firm pressure is necessary to attach the components.
Attach PRO-2800 to Video Housing with the SA-100 Ball
Socket Arm and Flex Arm
Ball Mount
Knurled Nut
Handle Stud
Battery Pack
Cord End to
Battery Female
Connector
Wingnu
t
3/8” Washer
SA-100
Ball-Socket Arm
Arm
Mount
Cord End to
PRO-2800
Flex Arm
Attach Battery Pack to DSLR Housing
1. Turn the housing upside down so the Battery Pack attachment holes on the bottom of the tray
are facing up and to the back of the housing as shown in
Diagram H - Page 11
.
2. Loosen and adjust the Housing Tray (move forward or backward) until the back of the Tray is
aligned with the back of the DSLR housing. Re-tighten Housing Tray Bolts firmly enough to
secure the Tray, but do not over-tighten.
Female Connector
with Waterproof Cap
Female Connector with
Waterproof Cap removed
Cord End to
Battery Female
Connector
Cord End to
PRO-2800
