Ikegami MKC-230HD, Руководство по эксплуатации

Страница: 15 / 50

14
3.2. Electrical Connection
1.
Before turning on the power, confirm that the external devices (camera head,
monitor, etc.) are correctly connected.
2. Turn on power supply to the monitor and other external equipment.
3.
Turn on power supply (
main power switch
) of CCU
back.
Ɣ The supplied power cable should always be connected to the AC inlet on the CCU back.
Ɣ When it is powered up, the power button on the front will light up in green.
Ɣ It can be powered off by pressing the power button or turning OFF the main power switch
with the power button lit.
Ɣ Immediately after power-up, the CCU and the camera head will be initialized automatically.
During this time, a monitor screen is unstable; however, this is not a failure.
4.
The video image from the camera is output under the same setting condition with
the last use.
Ɣ
When power is turned off in the state of still screen picture, that state will not be held even
if power is turned on again, and MKC-230HD is set to the normal shooting state.
* When moving the CCU, be sure to turn off the POWER, disconnect the power plug and
remove the connecting cable between equipment beforehand.
* If the cable comes loose during use, repeat the steps described above.
CAUTION:
Caution for Camera cable connection and disconnection
Turn off the power of MKC-230HD when you connect or
disconnect the camera cable. If the CCU is turned on, it may
cause the fault of MKC-230HD.
NOTE: Phenomenon on video image
MKC-230HD may happen following phenomenon on its video image.
It is not failure but it is because of employing CMOS sensor.
When its sensitivity gain is going up, it may appear high lighting dots.
In case under high temperature condition, it may be remarkable.
It may appear horizontal stripe pattern or flicker on a video image
under the fluorescent lighting. In this case, please use manual
electrical shutter of 1/100 (50Hz area). It will be reduce, but please
note that it will not disappear at all.
In case of fast moving object on a video image, it may appear
distortions.