E-3
4. Camera Installation
4-1. Pre-work before installation
For camera fixing, two holes are needed.
68.5
Holes for camera fixing
4-2. Mounting the camera (Ceiling)
Put two fixing screws leaving about 5mm clearance. Those two screws
will be tightened later to secure the dome camera. Put the cable wiring
through the center hole of the camera base
①
, and align two key hole slot
to the screws.
And turn the unit clockwise until it stops and tighten two fixing screws. Put
back the dome cover.
5mm
①
③
②
Screws
Camera
Dome cover
4-3. Mounting the camera (Wall)
The way of installation is the almost same as to
a ceiling. Install the main unit so that the switch
becomes upper side as shown in the illustration
right and set the “FLIP” in the setup menu to
“V-FRIP”.
Upper
Lower
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]
