42
EN
CARE AND CLEANING
Cleaning the sealed burners
To avoid possible burns, do not attempt cleaning
before turning off all surface burners and allowing
them to cool.
Any additions, changes, or conversions required in
order for this appliance to satisfactorily meet the
application needs must be made by an authorized
quali
fi
ed Agency. Routinely clean the cooktop. Wipe
with a clean, damp cloth and wipe dry to avoid
scratches. Keeping the surface burner head ports
and slots clean will prevent improper ignition and an
uneven
fl
ame.
To clean recessed and contoured areas of cooktop:
• If a spill occurs on or in the recessed or con-
toured areas, blot up spill with an absorbent
cloth.
• Rinse with a clean, damp cloth and wipe dry.
Burner Cap
Burner Head
Burner Cap Lip
CAUTION
• To avoid possible burns do not attempt to op-
erate the surface burners without the burner
caps.
• Do not use spray oven cleaner on the cooktop.
Figure 21: Burner Cap
To clean burner heads:
1. Remove the burner cap from the burner head.
Clean the cap with hot soapy water and dry
thoroughly.
orifice port
slots
ignition port
ignitor
Figure 22: Cooktop cleaning
7. Before using the cooktop again, make sure the
burner caps are properly placed and seated on
the burner heads. When placed correctly, the
burner cap is centered on the burner head and
will click into place on the burner head. You
can wiggle the cap to test placement, it should
not move off the burner head “Figure 5: Gently
move cap for proper placement” on page 14.
Important notes:
• The surface burner heads are secured to the
cooktop and must be cleaned in place on the
cooktop.
• Always keep the surface burner caps in place
whenever a surface burner is in use.
• When replacing the burner caps, be sure the
burner caps are seated
fi
rmly on top of the
burner heads.
• For
proper
fl
ow of gas and ignition of burners
do not allow spills, food, cleaning agents, or any
other material to enter the gas ori
fi
ce port open-
ing.
2. For burned-on and dried spills, apply hot soapy
water to the burner head. Allow time for the
soils to soften.
3. Use a toothbrush to clean all over the burner
head.
4. Use the toothbrush to clean the slots and holes
in the burner.
5. Use a needle or
fi
ne wire to clean out the igni-
tion port (see Figure 22).
6. Wipe the burner head clean with a soft, clean
cloth, sponge, or scratch-free cleaning pad.
Содержание GRUNDLAGGA
Страница 1: ...ES FR EN GRUNDLÄGGA ...
Страница 144: ...A17725612 B June 2020 Inter IKEA System B V 2020 23430 AA 2195057 3 ...