bevel 30 degree
selfadhesive tape
rudder/elevator
fin/stabilisator
retainer straps
control arms
stopper
stabiisator
elevator
<>
Ca. 5mm
Tail wings
5.) Cut or sand a 30 degree bevel in the rudder/elevator of the tailplane. When this is done attach them using
adhesive tape to hinge the surface as shown.
6.) Cut holes in elevator and rudder ( ¼ “ back
from the hinge line). Locate the control arms and
the backers with epoxy. The backers are used to
reinforce the construction.
Wings
7.) Use a pair of scissors to cut out the wing
joiners.
monocoques
3
