30
Programming:
•
Plug in receiver battery. LED fl ashes red.
•
Push both transmitter control sticks into any corner and hold.
•
Turn on transmitter; wait for “CONFIRM.”
•
Release control sticks and move pitch to minimum position; “CONFIRM.”
•
Tail stick all the way to the right; “CONFIRM,” release tail.
•
Pitch forward stick all the way to the front; “CONFIRM,” release pitch forward.
•
Roll stick all the way to the right; “CONFIRM,” release roll.
Optional:
•
Switch Flight phase to Acro; “CONFIRM,” back to normal.
•
Three-position switch Mode to setting Heading Lock; “CONFIRM,” back to motors Off.
•
Successively toggle additional switches; “CONFIRM,” back.
•
Set Pitch all the way to the front and back again, long “CONFIRM.”
Programming fi nished, (Signal: disconnected); LED fl ashes green.
Programming fi nished, (Signal: disconnected); LED fl ashes green.
Adjusting swash plate
This operation is useful if the servos have been replaced. With roll (right, center, left) the servo is chosen, with for-
ward pitch the zero setting is changed.
Preparation:
•
Center all transmitter trimmers.
•
Turn off transmitter.
Adjustment procedure:
•
Plug in receiver battery. LED fl ashes red.
•
Push forward pitch and roll sticks to any side and hold.
•
Turn on transmitter; wait for “CONFIRM.”
•
Set pitch to maximum; wait for “CONFIRM.”
•
Pre-select with roll servo (Right, Center, Left)
•
Change zero position with forward pitch (full defl ection) until the swash plate stands horizontal and at the
correct height.The center of the adjustment range is displayed with “CONFIRM.”
•
Pitch to minimum fi nishes adjustment and saves the new settings.
After this adjustment the model must be retrimmed, for this purpose erase model trimming fi rst.
GigaTronic System Flow Chart
Roll-curve
Akro
Hover
Tail mixing
Throttle effect
Throttle change
Pitch/
Throttle
Main motor
/ Throttle
servo
Tail motor
/
Tail-servo
Throttle Curve
composation
Gyro sensitivity
Heading sensitivity
Yaw axis
Copter
Gyro Offset
( function
)
Mode
Yaw
Forward
Pitch
Roll
Shaft governor
Akro
Phase
Pitch-curve
Acro
Hover
Throttle
Acro
Hover
Tail- curve
Acro
Hover
Tail stick
effect
Soft
start
Head
system
Load change effect
Heading intensity
Load change duration
Heading fade out
Holding range
Gyro
Feedback control
Gyro effect
Tail start setting
/ Combi tail setting
Mixing
Gyro- Mode
Acro
Programmed curves
Hover
Heading-mode
Function
Model
Acro
Shaft governor
Hover
System settings
en
Forward Pitch
Curve Acro
Hover
