www.ikancorp.com | 1.713.272.8822 | [email protected]
because we’re
filmmakers
too
General Guidelines
Please make sure there are NO FLAMMABLE MATERIALS close to the fixture while operating, to prevent any fire hazard.
This fixture will heat up due to the fact that the heatsink for the light is the aluminum shell.
The fixture must be installed in a location with adequate ventilation, at least 1.5 feet (.5m) from adjacent surfaces. Be sure no air ventilation slots are
blocked.
The fixture is equipped with a fan for cooling it is advisable to run the fan when the light is on for any period of time.
This fixture will run for up to 1 hour before the light will overheat and shut down. The circuit breaker will engage and must be reset before the light can be
re-energized and used again. (Note: Cooling down times may vary)
DO NOT attempt installation and/or operation without knowledge of how to do so.
DO NOT permit operation by persons who are not qualified to operate this type of fixture. Most damages are the result of operations by nonprofessionals.
Consistent operational breaks may ensure the fixture will function properly for many years to come.
DO NOT shake fixture and avoid using brute force when installing and/or operating the fixture.
Always install the fixture with an appropriate safety cable. When installing the fixture in a suspended environment, always use correct mounting hardware
that can be inserted into the 5/8”receiver.
Use the original packaging and materials to transport the fixture in for service.
This Fixture will heat up due to the fact that the heatsink is the aluminum body.
