IKA RV 10 auto, Руководство по эксплуатации

Страница: 27 / 160

27
Error message Effect Cause Correction
Temperature calibrati-
on error Temperature calibration value is
out of range Wrong simulator resistance is
chosen
PCB is broken Check the simulator resistance
Contact service department
Temperature adjust-
ment error Water in and water out sensor
temperature have big deviation The cooling water temperature
is changing
Temperature sensor is not cali-
brated
Temperatrue sensor is broken
Check the chiller and wait until the chiller
reaches the set temperature
Make sure there is no distilling
Contact service department
Contact service department
Inside temperature
too high Analysis of internal PCB temp.
Sensor.
Inside temperature reaches limit
value. Room temperature > 40°C
PCB is broken Switch off device to cool down
Contact service department
Flow rate out of range Water flow rate of cooling wa-
ter is out of range
Water flow rate is too high
Water flow sensor is damaged Reduce the water flow rate
Contact service department
Flow rate too low Water flow rate of cooling wa-
ter is less than the minimum li-
mit value Water flow rate is too low
Water flow sensor is damaged Increase the water flow rate
Contact service department
Condenser overload Cooling power limit value is ex-
ceeded Condenser limit value is too lo-
wer
Distilling is too fast Increase the condenser overload limit
Increase the set vacuum
Distillation dry There is no more solvent dis-
tilled Distillation is completed Stop the distilling
Lift error Lift can not reach the end po-
sition Lift is overloaded or lift is blo-
cked
Position sensor failure
Lift motor, cable or PCB is da-
maged Check the lift
Contact service department
Contact service department
Internal communica-
tion error Internal Communication Error Internal communication error Switch device on/off, Contact service de-
partment
PC communication
error Error command received from
PC via RS 232 or USB interface LWS uses wrong device for RV
10 control
Wrong tools are used to com-
municate with RV 10 control
Unstable connection Check the LWS setting
Check the PC tools
Check the connection
Heating bath commu-
nication error Communication with heating
bath is not available Infrared interface is blocked
Heating bath is switched off or
detect error
Heating bath with infrared in-
terface is not present
PCB is damaged Check and clean the infrared interface
Switch on heating bath
Check the heating bath
Contact service department
EEPROM error Error while reading or writing
the EEPROM EEPROM is defective Contact service department
Storage error Read or write internal flash er-
ror Read or write internal flash er-
ror Contact service department
If the actions described fail to resolve the fault or another error message is displayed, then take one of the following steps:
- contact
IKA service department,
- send the device for repair, including a short description of the fault.
Warranty
In accordance with IKA warranty conditions, the warranty period
is 24 months. For claims under the warranty please contact
your local dealer. You may also send the machine directly to our
factory, enclosing the delivery invoice and giving reasons for the
claim. You will be liable for freight costs.
The warranty does not cover worn out parts, nor does it apply
to faults resulting from improper use, insufficient care or
maintenance not carried out in accordance with the instructions
in this operating manual.
Note: For claims on glassware units, please contact your local
dealer and do not send the glassware back to our factory.