IKA C 1.30, Руководство по эксплуатации

Страница: 7 / 20

7
Page Page
Declaration of conformity 2 Function 8
Contents 6 Maintenance and cleaning 9
Explanations of symbols 6 Fault table 9
Safety instructions 6 Warranty 9
Unpacking 7 Spare part list 17
Setting up of the instrument 8 Spare parts 18
Explanations of symbols
Safety instructions
Read the operating instructions in full
before starting up and follow the safety
instructions.
Keep the operating instructions in a place where
they can be accessed by everyone.
General hazard
This symbol identifies information which is of absolu-
te importance for the safety of your health . Non-
compliance may lead to impairments to health and injury.
This symbol identifies information which is important for
proper operation and handling of the decomposition
vessel. Non-compliance may result in imprecise measure-
ments or damage to the venting station.
Unpacking
• Unpacking
- Please unpack the device carefully
- In the case of any damage a report must be sent immediately
(post, rail or forwarder).
• Delivery quantity
a) Base plate
b) Gas washing bottle
c) GL screw joint
d) Pressure tubing
e) Drainage hose
g) Fork spanner
h) Set of O-Rings
i) Operating instructions
a
b
c
d
e
Ensure that only trained staff work with the appliance.
Follow the safety instructions, guidelines, occupational health and safety and
accident prevention regulations.
Furthermore, toxic combustion residue in the form of gases, ashes or condensation,
for example, is possible in the inner wall of the washing bottle.
Observe the accident prevention requirements applicable to
the activity and the work station.
Wear your personal protective equipment.
When handling combustion samples, combustion residue and auxiliary materials,
please observe the relevant safety regulations. The following materials, for
example, could pose a risk:
- corrosive
- highly flammable
- explosive
- bacteriologically contaminated
- toxic
Combustion gases are hazardous to health, there-
fore the venting hose must be connected to a suitab-
le gas cleaning system or extraction system.
DANGER
DANGER
The C 1.30 venting station is used for controlled venting
of IKA C1 calorimeter.
The venting speed may be infinitely adjusted via a throttle valve by using a
manual adjusting screw. Please note that the throttle valve is
closed at the
beginning of the venting operation.
Do not operate without the ground clamp included in the delivery quantity!
The maximum permitted operating pressure is 40 bar (at the pressing tubing
(d) ).
Please observe the general laboratory guidelines when handling glass vessels.
c
e
}
DANGER