IKA 06-5819, Руководство по эксплуатации

Страница: 17 / 48

IKA
®
-WERKE
15
2.1 Construction of the ULTRA-TURRAX

2.1.1 Sealing cartridge
Into the pump casing (710) a sealing cartridge (500) is integrated. This sealing car-
tridge essentially consists of a sealing casing, a double-acting mechanical seal and a
drive sleeve. The seal has following characteristics: The slip ring on the product side
has few fissures or only very small fissures projecting into the product space, thus
reducing product collection in fissures, and has spring elements that do not contact
the product. The slip rings as well as the secondary seals can be adjusted to the
planned operating conditions by choosing suitable materials.
2.1.2 Mixing tools
The mixing tools (1004, 1006) for this machine are located above the sealing car-
tridge on the motor shaft. All tools are individually removable and can be optimally
adjusted to meet the goals of the process. Their purpose is to bring the components
to be mixed into contact with one another, thoroughly mix them and to discharge the
mixed product from the machine.
•
The machine is a single-stage machine, i.e. there is one mixing tool used (rotor)
with one stator.
•
3 standard tools, coarse, middle and fine stage which can be differentiated by the
number of teeth and slots.
•
The tool to be used differ, depending upon the mix-zone. This tool is mounted on
the motor shaft and is fixed in place with the special screw (730).
2.1.3 Drive
The power transmission of the motor (100) is made by a shrink disc (260) directly to
the plentifully dimensioned drive shaft (426). On the drive shaft is the mixing tool
(1004).
2.1.4 Frame
The UTL 1000/10 can be ordered optionally with base frame. The frame allows the
machine to be set up securely on the floor. To decouple the machine from the sup-
porting surface it rests on rubber buffers