10
SETTING AND USING THE SLEEP TIMERS
You can easily set your sleep timer presets using the iHome Zenergy™ app.
SETTING THE SLEEP TIMER FROM THE UNIT
Sleep mode lets you sleep to built-in lights, sounds, your Bluetooth device,
FM radio or Aux-in for the set sleep duration, then turns the unit off. There
are two sleep modes, Sleep 1 and Sleep 2, each set the same way.
Directions below show Sleep 1 Button. Use Sleep 2 Button to set Sleep 2
mode. Press the sleep button to go straight into sleep time setting with
current settings. Otherwise follow steps below. Unit must be powered on
for sleep mode.
1.
Press and hold
the
Sleep 1 Button
or 3 seconds. The current Sleep 1
audio source and “ZZZ” will flash in the display. Press the
+
or
–
Buttons
to select the desired sleep audio source: SOUNDS, PHONE (Bluetooth),
RADIO, AUX-IN* or NONE (no sleep audio).
2. Press the
Sleep 1 Button
to confirm sleep audio source.
a. If Sounds or Radio was selected, the current sound or radio frequency
will flash. Press the
+
or
–
Buttons
to select the desired sound or radio
station.
b. If None was selected, the current Light mode will appear. Press the
+
or
–
Buttons
to select the desired light mode.
c. If Phone or Aux-in was selected, the current sleep volume will appear.
Press the
+
or
–
Buttons
to select the desired sleep volume.
3. Press the
Sleep 1 Button
to confirm and advance to volume setting, light
mode or light brightness setting, depending on previous audio
selection. Press the
+
or
–
Buttons
to select the desired setting.
4. Press the
Sleep 1 Button
once to confirm your ultimate desired setting.
5. Continue in this manner until ”120” appears on the display. Press the
Sleep
1 Button
as needed to cycle to the desired sleep duration: 120, 90, 60,
30, 15 minutes or OFF (turns unit off). When the desired sleep duration
is displayed, allow Sleep 1 setting to time out (do not press any buttons
for about 10 seconds). Your sleep timer will be active upon exiting.
(
Continued on page 11
)
