18
Preparing the Remote Control
Inserting batteries into the remote
control
Use two R03 or LR03 (size AAA) batteries.
Two R03 (size AAA) batteries are supplied with the unit.
Remove the cover and insert the batteries.
Remove the cover and insert the batteries.
To remove the cover, lift its latch
while
pressing it in the direction.
Check the polarity markings
+
and
-
to insert the
batteries correctly.
Top of the cover
Bottom of the cover
To close the cover, insert the protrusion at the bottom of
the cover into the notch on the remote control and then
push down the top of the cover until a click is heard.
About batteries
• Battery life differs depending on how the battery is used. Replace
both of two batteries with new ones if you experience difficulty in
using the remote control or if the signal transmission distance
shortens.
• Dispose of the used batteries following your local regulations for
disposal.
Connecting the Power Cord
Be sure to connect the power cords of both the
unit and connected equipment only after all the
connections have been done.
CAUTION!
Do not use the supplied power cord for any
device other than this unit.
The supplied power cord is exclusively for
this product.
Connect the power cord to the amplifier
first, then to the wall outlet.
Connecting to the wall outlet should
be the last connection made.
Power cord
Power cord
(supplied)
(supplied)
Connect the power plug in the above order and . Firmly
insert the power plug fully into an AC120V outlet.
Be sure to power OFF the unit before disconnecting the power
plug.
HAV-R400G_R500G.indb 18
HAV-R400G_R500G.indb 18
11/10/2011 9:31:27 AM
11/10/2011 9:31:27 AM