24
MAINTENANCE INTERVALS
Maintenance work must be done at regular intervals. Failure to do so will result in excessive wear and early failures.
Explanation of the service intervals:
•
10:
Every 10 hours or daily (before starting the machine).
Service Schedule
O
Check condition / proper operation. Adjust or replace as needed.
G
Grease.
Item
Service Required
Service Interval (hours)
10
Mainframe
Check frame and welds.
O
Hardware
Check all bolts and nuts are tight.
O
Lubrication
Lubricate grease fitting.
(See Lubrication Locations on Page 24)
G
LUBRICATION LOCATIONS
Always use a good quality lithium based multi-purpose
grease when lubricating the implement. Apply lubricant
until extra grease shows.
IMPORTANT
ENVIRONMENTAL HAZARD
Fluids such as engine oil, hydraulic fluid, coolants,
grease, etc. must be disposed of in an
environmentally safe manner. Some regulations
require that certain spills and leaks on the ground
must be cleaned in a specific manner. See local
regulations for correct disposal methods.
◂
I-2067
WARNING
IMPACT AND INJECTION HAZARDS
Flying debris or pressurized fluids can cause serious
injury or death.
Wear safety glasses to prevent eye injury when any
of the following conditions exist:
•
When fluids are under pressure.
•
Flying debris or loose material.
•
Engine is running.
•
Tools are being used.
◂
W-2019
Figure 30
p-96210a
REF.
LOCATION
NO. OF
FITTINGS
1
Pivot assembly
1
