IGM Laguna CFlux3Tv2, Руководство по эксплуатации

Страница: 6 / 18

-6- www.igmtools.com
5. Assembly
5.1 Unpacking
Your 3HP Mobile Dust Cyclone comes packed in a single box. Before
attempting to assemble this machine, follow these directions for
unpacking:
1. Carefully cut the banding straps and remove them from the box.
2. Cut along the tape line at the top of the box.
3. Remove all parts from the top of the styrofoam and set aside.
4. Remove the styrofoam packing material from the top of the machine.
5. Carefully take out the machine components from the box and set aside.
6. Using the diagram below, ensure that all parts are present and in good
condition.
Description
A. Motor
B. Switch and remote controller
C. Dust chute
D. Top upright supports (3)
E. Canister 1 Micron
F. Base frame
G. Rotation shaft
H. Rotation paddle (2)
I. Crossbar
J. Octagon drum lid
K. Cyclone funnel
L. Cyclone barrel
M. Intake cylinder
N. Canister cover plate
O. Octagon front and back panel
P. Octagon drum foot pedal
Q. Inlet adapter
R. Lower upright supports (3)
S. Drum insert
T. Upright support reinforcement plate (3)
U. Foot pedal bar (left and right)
V. Foot pedal assembly fittings
V1. Lower triangular support plate (2)
V2. Foot pedal bar support (2)
V3. Lower support plate (2)
W. Hardware box
X. Operating and Parts Manual
Y. Dust bags
Report any missing or damaged parts to your dealer or distributor. Prior to
tool assembly and use, read this manual thoroughly to familiarize yourself
with proper assembly, maintenance and safety procedures.
5.2 General Tool Assembly
This step requires two adults. This 3HP Mobile Dust Cyclone is heavy,
be careful when lifting and handling it! Failure to comply may cause
serious injury and/or damage to the machine and/or property!
Tools Required
10 mm wrench / 12 mm wrench / 14 mm wrench
Phillips screwdriver. 4 mm hex wrench / 5 mm hex wrench
To assemble your dust cyclone, follow these steps:
For your own safety, do not connect the machine to the power source until
the machine is completely assembled. Please also make sure that you
read and understand the entire instruction manual.
ASSEMBLY TIME ESTIMATE 4-5 hours
Step 1: Turn the unit upside down. Make sure you use a cushion under
the canister top side to even out the unit to the same height as the motor.
Do not have the unit lopsided. Remove the base (G) which has been
fastened to the (3) top upright supports (E).
Step 2: Secure the (4) 76 mm wheels to the underside of the base (F)
using (16) 8 mm*19 mm hex bolts and (16) 8 mm*OD18*2T flat washers.
Step 3: Turn the base (F) around with it standing on the 4 red
wheels and secure the three lower upright support panels (P) using hex
bolts (6) 9 mm*19 mm and flat washers (6) 9 mm*OD23*2T.
Each lower upright support panels (P) numbered for its specific location.
A – shown with one dot is located on the canister side. B – shown with two
dots with extension on left is located on the front side. C – shown with two
dots with extension on right is located on opposite end.
Step 4: Install the foam tape to the upper and lower rims of the three
components listed, Cyclone funnel, Cyclone barrel, and Intake cylinder.
Receiver set
button
Hardware
box
Manual