IGM Laguna CFlux3Tv2, Руководство по эксплуатации

Страница: 9 / 18

-9- www.igmtools.com
Step 20: Take the Octagon drum side panels and assemble together,
secure with (40) M4*12mm sheet metal thread bolts. Take note of the left
and right panels; do not assemble the incorrect sides. Refer to the next
step.
Step 21: Front and back panels of the Octagon should be bolted together
to prevent any confusion. Please assemble them together per photo
below.
Step 22: Both the left and right side lift panels have three bolt holes on
them. Take the matching side plate and secure to the outside of the
panel. (Photo shown is the inside of the panel) using carriage bolts (6) 6
mm*12,7 mm, flat washers (6) 6 mm*OD19*2T and hex nuts (6) 6 mm.
Step 23: Take the Octagon base panel with wheels and secure on to the
bottom of the drum using M4*12mm sheet metal thread bolts.
Step 24: Once completing the assembly, apply silicone to the inside of the
drum including the base to seal and prevent air leakages and air flow loss.
Step 25: Attach the handles to the top and bottom end on the front
panel with the window display using (4) flat head Philip bolts, (4) flat
washers 8 mm*OD23*2T and hex nuts (4) 8 mm.
Step 26: Attach the rubber gasket to the top inner edges of the
Octagon drum. The wider end of the gasket goes up. You will need tin
snips to trim any excess rubber gasket after completing the seal.
Step 27: Insert the plastic bag inside the Octagon drum. Open and
spread out the plastic bag to the corners and edges.
Step 28: Place the drum insert inside over the plastic bag in the
Octagon drum.
Rubber gasket