3D sensor
4
1. Preliminary note
This document is intended for specialists. These specialists are people who are qualified by their
appropriate training and their experience to see risks and to avoid possible hazards that may be caused
during operation or maintenance of the device. The document contains information about the correct
handling of the device.
Read this document before use to familiarise yourself with operating conditions, installation and operation.
Keep this document during the entire duration of use of the device.
1.1 Symbols used
►
Instructions
>
Reaction, result
[…] Designation of keys, buttons or indications
→
Cross-reference
Important note
Non-compliance may result in malfunction or interference.
Information
Supplementary note
1.2 Warnings used
NOTE
Warning of damage to property.
2. Safety instructions
2.1 General
These instructions are an integral part of the device. They contain texts and figures concerning the correct
handling of the device and must be read before installation or use.
Observe the operating instructions. Non-observance of the instructions, operation which is not in
accordance with use as prescribed below, wrong installation or incorrect handling can seriously affect the
safety of operators and machinery.
2.2 Target group
These instructions are intended for authorised persons according to the EMC and low-voltage directives.
The device must be installed, connected and put into operation by a qualified electrician.
2.3 Electrical connection
Disconnect the device externally before handling it.
The connection pins may only be supplied with the signals indicated in the technical data and on the
device label and only the approved accessories of ifm may be connected.
2.4 Tampering with the device
In case of malfunctions or uncertainties please contact the manufacturer. Any tampering with the
device can seriously affect the safety of operators and machinery. This is not permitted and leads to the
exclusion of any liability and warranty claims.
