ecomatController CR710S/CR711S
18
6 Set-up
WARNING
Note the following:
●
Functions and features
●
Programming and important additions to these instructions
●
Set-up
6.1 Interfaces and system requirements
The programmer creates the application program with the IEC 61131-3 compliant
programming system CODESYS and loads the applications via the Ethernet, RS-
232 or CAN interface to the controller�
System requirement for CODESYS 3�5 SP10:
Microsoft Windows 7, SP1 or higher
For applicable CODESYS versions see the ecomatController CR710S /
CR711S system manual�
6.2 General
As delivered, the device is prepared for programming with CODESYS version 3�5
SP10 or higher�
Factory settings:
IP address: 192�168�82�247
Subnet mask: 255�255�255�0
The user is responsible for the safe function of the application programs
which he created himself� If necessary, he must also obtain an approval
from the supervisory and test organisations according to the national
regulations�
6.3 Getting started
►
Check if the pre-installed, latest version of the ifm operating system is required�
If necessary, download and install a different version via TFTP�
►
Connect the device to the notebook/PC via the Ethernet interface�
►
Switch on the notebook/PC; Check the IP settings of the notebook/PC and
change them if necessary�
Internet protocol: TCP/IP
IP address: 192�168�82�xxx (except for �247, s�a�)
Subnet mask: 255�255�255�0
Gateway IP address: 192�168�82�21
►
Switch on the operating voltage of the device�
> After the operating voltage has been applied, a project can be loaded�
