IO-Link master with USB interface 1 port IP 65 / IP 67
16
>
9.2
Port 1: Configuring operating mode pin 4
60830
Pin 4 (C/Q) of the IO-Links port supports the following operating modes:
•
Disabled: no data transmission
•
Digital input (DI): digital input signal
•
Digital output (DO): digital output signal
•
IO-Link: IO-Link data transfer
To set the operating mode of the IO-Link port:
► Select [Port 1] menu.
>
The menu page shows the current settings.
► Set the following parameters as required:
Parameter
Description
Possible values
[Port1 Mode Pin4 US]
Operating mode of the IO-Link port (pin 4)
Disabled
No data transmission
DI
Digital input
DO
Digital output
IO-Link
IO-Link
[Port 1 Cycle time actual]*
Current cycle time of the data transmission
between IO-Link master and IO-Link device (read
only)
Value in microseconds
[Port1 Cycle time preset]*
Requested cycle time of the data transmission
between the IO-Link master and the IO-Link device
0
Device sets the best possible
cycle time itself.
1
...
132800
1 microsecond
...
132800 microseconds
[Port1 Bitrate]*
Transmission rate of the IO-Link device (read only) Value in kbaud
* ... only available if [Port 1 Mode Pin4 US] = IO-Link
► Save changed values on the device.
