![background image](http://html1.mh-extra.com/html/ifm/ac1401-02/ac1401-02_device-manual-supplement_3905571063.webp)
63
ifm
Device Manual Supplement: Acyclic data records and Command interface (AC14 and AC4S)
2017 / 09
Command channels
>
4.3.3
Command 0x0001 – Change parameters of an AS-i slave
8799
Requirement:
The addressed AS-i master must be in the protected mode.
Command 0x0005 – Change the operating mode of the AS-i master
(
>
Command request channel (fieldbus master >>> device)
11103
Offset
Word no.
Bit
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
0
1
UID
2
command number
3
reserved
reserved
ST
SLA
4
reserved
reserved
New output parameter
5...120
The area is completely ignored.
It does not matter whether the data area exists or what data is contained.
Legend:
SLA
slave address
5 bits
0x00…0x1F = 0…31
ST
slave type
1 bit
0 = single slave or A slave
1 = B slave (= addition of 0x1F to the slave address)
UID
user ID
1 word
0x0000…0xFFFF = 0…65535
The user ID ensures clear identification of the commmand response data
of the command request data sent before. The user can assign any user
ID in the command request. The AS-i master reflects the user ID from the
command request into the corresponding command response.
If the requested slave address (SLA) is not in the list of activated slaves (LAS), the new
parameters are stored in the AS-i master despite error message (error code 0x0A). If an AS-i
slave with this address is added to the AS-i network at a later point, the slave automatically
adopts the saved parameters.