Flamconnect
GW-10
ENG
Installation and Operating instructions
flamcogroup.com/manuals
Mount the antenna on the ‘cell‘ connection
Fix the gateway near the device. Make sure the antenna is
not surrounded by lots of metal parts or casing as this might
interrupt the cellulair signal.
LogoTronic controller (SG0004)
Connect RS485 cable to the LogoTronic controller.
Make sure
the RS485 communication setting is on ‘HFC protocol‘.
Connect communication cable to the gateway
If supplied put th powerplug into the socket.
Flextronic controller (S90002)
Connect RS485 cable to the left RS485 port of Flextronic
controller. In the right RS485 a resistor needs to be placed.
Make sure the RS485 communication setting is on ‘Gateway‘.
SPC controller (S90000)
Connect the bushing plug onto the controller. The power
supply on the serial must be enabled via the device menu.
Registration gateway
Register the gateway on the Flamconnect portal. Please use
www.flamcogroup.com/register-gateway
or scan the
QR-code. Or fill in the serial number in the portal and press on
‘register device‘. The gateway needs 5 minutes to set up the
connection.
Dekimo controller (S9001)
Connect the bushing plug onto the controller.
1.
3a.
3c.
4.
3d.
3b.
2.
4
3
2
1
KP905251
