iEvo would like to thank you for purchasing our product.
This manual is designed to make your installation of our
superior biometric reader quick, easy and efficient.
Please ensure you check all of the points listed below and
read through the manual before commencing your installation. iEvo would also recommend making use of the 5
End User guides that are supplied with the reader, which can help train the users of the system to eradicate any
finger placement issues. For more End User guides or posters please contact us (Contact details can be found at
the back of this manual)
1. Ensure you have selected the correct reader for internal or external use. The external reader is supplied with a built in
thermostat controlled heating system. An internal reader, placed externally will not perform to it
’s required capabilities.
2. If you are fitting a flush mounted reader ensure you have the correct cut out template and have the correct mounting
and fixing plates provided in the box.
3. iEvo advise the use of a surged protected power supply unit. iEvo is designed to shut down as a protection precaution
when spikes or noise on line is detected. iEvo will reboot straight away after shutdown. The use of a correct power supply
will prevent this from taking place. Also, if you are using two power supplies please ensure that they are grounded
together.
4. We recommend that you install the iEvo reader at the DDA height of approximately 1 metre. This will be the perfect
height for finger placement.
5. Ensure you use good quality screened core cables at all times. Only use CAT5 cable for the network connection.
NOTE: If you remove the Ferrites to shorten cable length of the reader please replace Ferrites back onto the cable.
6. Each iEvo reader needs its own network cable, as each reader has its own IP address. Ensure this has been taken into
consideration before commencing with installation. See network pages.
7. Ensure you have calculated the correct power supply amp rating. If you are connecting the iEvo board and other
controllers/locking mechanisms to the same supply.
8. Please ensure you read all of the information notices in this manual before commencing installation. These are denoted
with a yellow triangle.
9. Ensure that the control box is installed on the protected side of the turnstile/door. Do not exceed
5 meters
in cable
length from the reader to the control box. You are provided with
2.95 meters
. Ensure good quality connectors are used if
cable is extended. The control box is not IP rated, it can be installed inside the power supply unit. There is a heartbeat
LED to show power to the box. The iEvo reader button is illuminated blue to show power to the reader.
10. Ensure you read the software set up manual for configuration of each installed reader.
11. iEvo has been designed to integrate into other manufacturers controllers and control boards. Our software has also
been integrated to ensure a smooth and seamless operation for the end user. We can support you on our software and
hardware. We are unable to support you on other manufacturers hardware and software. Please ensure you contact the
correct manufacturer if you require assistance.
Note:
iEvo is an independent company and manufacturer of iEvo products only. Although iEvo has integrated into other
manufacturers products with their consent, iEvo has no affiliation nor representations of the companies we have integrated
into. All companies that we have integrated into have no affiliation or representations of iEvo. None of the companies that
we have integrated into have endorsed iEvo in anyway nor do they have any legal attachment to any claims made by iEvo.
iEvo has no legal attachments to any claims made by the companies we have integrated into.
WELCOME
NOTE:
iEvo is NOT a door relay controller.
If you are going to have a high volume of users we
recommend purchasing an extra control box for registration. (This is due to the first iEvo
reader in your list being down when a user is being registered. This will stop the iEvo reader
working whilst registration is in progress)
1
Warning: When installing the Ievo control box, follow ESD Safety Procedures.
Ground yourself to prevent any damage to the electronic components.
Содержание ultimate
Страница 1: ......
Страница 5: ...Installation 4...
