Print More Materials, All For Application
35
Appendix B
How to use the platform glue stick
1.Before printing on the printing platform to apply solid glue evenly twice, as shown in the figure can
be based on the size of the print model vertical and vertical coating of the corresponding area.
。
Attention: The temperature of the carbon fiber board when applied cannot exceed 50℃, otherwise
the high temperature will quickly melt the glue stick resulting in uneven thickness of the applied glue.
2.
After using for a long time, when the residual glue on the platform is too much, you can take off the
carbon fiber board and rinse it with clean water and re-glue it.
Attention: It is recommended to use the side skirt attachment type for printing model with carbon
fiber board, to avoid the model printing warpage and other bad flat production.
When printing the model, it is recommended to observe the printing situation well before leaving the
printer. Observe the forming effect of the skirt to determine whether the height of the nozzle and
platform is appropriate.
As in the case of Figure 1.
The skirt line is loose and independent, and
separated by one root. This means that the nozzle
is a little far from the platform, you can increase
