Print More Materials, All For Application
13
3.2 Device Movement Check
Step 1
1.
As shown in the diagram
2.
Connect the device power to
the cradle power
Step 2
1.
Under normal condition, all
lights of the device are lit as
shown in the figure
Step 3
1.
Click the Z-axis up and down
respectively.
2.
Observe if it moves normally as
shown
Step 4
1.
Manually control the XY axis
movement through the touch
screen
2.
Observe if it moves normally as
shown
Step 5
1.Through
pre-heat
via
the
touchscreen.
2.The temperature can be set for the
hot bed, left nozzle, and chamber.
3.The temperature on the right
represents the set temperature.
4.The temperature on the left
represents the actual temperature.
5.The recommended bed temp for
the first warm-up：50℃±2℃.
6.Nozzle temperature：210℃±2℃.
7.Please be careful of high temps
and handle with caution.
Attention:
The chamber fan needs to
be turned on before the inner
chamber warms up, it is
recommended to use 100% of the air
volume used, and the temperature
chamber only supports a maximum
of 90 ℃ stable printing.
