IEM Mobil-O-Graph NG, Руководство по эксплуатации

Страница: 89 / 385

Product description
87
EN
Clearing the memory
The memory must be empty before every measurement, i.e. there must be no blood pressure data from the
previous patient in the memory. If there are still values in there, these can be cleared using the delete function of
the evaluation software.
You can clear the memory manually by holding down the start button for more than 5 seconds. As it is held down,
all segments of the LCD will be displayed first of all, then 1 tone burst will be emitted, the number of saved
measurements will be displayed briefly and then "clr" will be displayed. If the event button is now pressed for
more than 2 seconds within 5 seconds, all measurements will be deleted.
Setting the time/date
The Mobil-O-Graph
®
has an internal backup battery which allows the time to continue even after removing the
power pack or batteries from the battery compartment. Nevertheless, the time and the date should be checked
before every measurement series.
The time and date can be set with the respective evaluation software.
You can set the time and date manually by holding down the start button and pressing the event button. Now you
are in the "set time" mode. Use the start button to change each item and use the event button to jump to the next
display item.
Transferring patient data (ID)
The blood pressure monitor must be prepared by transferring patient data (ID) with the help of the HMS CS so
that correct data allocation is possible when reading out.
Further information about this can be found in the HMS CS operating manual under "accepting
patient ID".