IEI Technology TANK-600 Series, Руководство пользователя

Страница: 26 / 103

TANK-600 Em b e d d e d S ys te m
P a g e 14

Access can only be gained by SERVICE PERSONS or by USERS who have
been instructed about the reasons for the restrictions applied to the location
and about any precautions that shall be taken.

Access is through the use of a TOOL or lock and key, or other means of
security, and is controlled by the authority responsible for the location.
3.2 In s ta lla tio n P re c a u tio n s
When installing the TANK-600, please follow the precautions listed below:

Power turned off : When installing the TANK-600, make sure the power is off.
Failing to turn off the power may cause severe injury to the body and/or
damage to the system.

Certified Engineers : Only certified engineers should install and modify
onboard functionalities.

Anti-static Discharge : If a user open the bottom panel of the TANK-600, to
configure the jumpers or plug in added peripheral devices, ground themselves
first and wear and anti-static wristband.
3.3 In s ta lla tio n a n d Co n fig u ra tio n S te ps
The following installation steps must be followed.
S te p 1: Unpack the system.
S te p 2: Install a HDD.
S te p 3:
Connect peripheral devices.
S te p 4: Mount the system.
S te p 5:
Power up the system.
3.4 Ha rd Dis k Drive (HDD) In s ta lla tio n
To install the hard drive, please follow the steps below:
S te p 1:
Remove five retention screws from the rear panel, as shown in Figure 3-1 .