45
Appendix C: Wake-up Function
How to Use Wake-up Function
SAGP-648E provides two kinds of Wake-Up Function.
This page describes how to use the Modem Wake-Up and LAN Wake-Up functions.
Wake-Up function works when ATX power supply is in use.
Wake-Up By Modem Ring On:
In CMOS SETUP, the user must set Resume On Modem Ring status to Enabled.
The ATX power supply will be switched on when there is a ring signal detected on
the pin “RI” of the serial port.
Wake-Up On LAN:
When the computer is in power-down status, a LAN Link/Active LED is flashing.
This status indicates that the LAN chip has entered standby mode and is waiting
for a Wake-Up signal. You can use other computers to wake up your computer
by sending ID to it.
ID: ID is the address of your system LAN. Every LAN chip has a factory default
ID, which can be found from network information in WINDOWS.
ID’s format is xx-xx-xx-xx-xx-xx
Example ID: 00905C21D4
