IDX CW-1dx, Инструкция по эксплуатации

Страница: 27 / 36

５）
From the receiver (RX) setting page indicated below, operation mode
changes from Access Point Mode (as the master unit) to Station Mode (as the
slave unit).
Select “Station” from the selectable list circled #1, then execute “Save” in the
circled #2. *After execution, the device will reboot automatically.
After reboot, make sure to check no RX’ SSID indicated on Wi-Fi.
Above competes the master unit (Access Point Mode) / slave unit (Station
Mode) change settings. The same procedure applies when returning.
★
IMPORTANT NOTE 1
Be sure to set the slave unit (Station Mode) to the master unit (Access Point
Mode) first. If both transmitter (TX) and receiver (RX) are slave units, Wi-Fi
connection will not be possible.
★
IMPORTANT NOTE 2
If the receiver (RX) is the master unit (Access Point Mode), the IP address
setting is automatically performed by the receiver (RX) and Wi-Fi connection
is established immediately.
However, if the transmitter (TX) is the master unit (Access Point Mode), IP
address need to be set when connecting to Wi-Fi.
In the case of same smartphone and CW-1dx TX being used, the second
and subsequent connections are performed automatically. The following
settings are only required for the first time.
26