101-001 (iTDC), 101-002 (EIO88), 101-145 (iTDCSR) -42- Users Manual
IDTeck – iTDC 2~4 DOOR ACCESS CONTROLLER
10.1.3 KEYPAD INPUT SETTING
* READER2, READER3 and READER4 KEY IN set-up is the same as above.
10.1.4 DURESS MODE SETTING
READER 1 DURESS
NOT USE(default)
USE
DURESS 1 P/W
<ENT>
Searching key<4> or <6>
<ENT>
ENTER NEW P/W
( <ENT>)
<ENT>
<ENT>
<ENT>
READER1 KEY
READER1 KEY
☞
. This function is to set DISABLE/ENABLE the keypad inputs
from the Proximity and Keypad Readers. The default setting is
DISABLE the keypad inputs. If you install Keypad Reader (8bit
burst format) and set this mode ENABLE, you can access the
Door by pressing 8digit User ID from the keypads.
Press <ENT> key and press <4> or <6> key to select ->ENABLE
then press <ENT> key to set-up this function.
☞
. You can select whether the DURESS mode is used or not used for
READER1. To use this function, you need Keypad Reader.
Default setting is NOT USE. If you want to set-up Duress mode
then press <ENT> key and select ->USE by pressing <4> or <6>
key then press <ENT> key. LCD will display default Duress
Password ‘00’. Press <ENT> key again to enter 2 digit Duress
Password then press <ENT> key to finish setting.
Note!!
In case of Duress, enter the 2 digit Duress Password and <ENT>
key then present the card. Door will be opened as normal but the
Duress alarm will be generated and reported to the host PC
READER1
READER1
DURESS 1 P/W
DURESS 1 P/W
