Copyright©2010-2014,InternationalTechnologies&SystemsCorp.Allrightsreserved.
Page14of19
UsingtheViVOpayKioskIItoMakeaPurchase
Presenting Cards, Fobs, or NFC Phones
Your new ViVOpay Kiosk II allows for credit/debit card purchasesusing the new
contactless technology.
Present the card/fob/phone in close proximity tothe front portion ofthe antennamodule.
Present the card/fob/phone so that maximum surfacearea is parallel to the antenna
module as shown below. The antenna should beep and all four green LEDs should
illuminate briefly to indicate a successful test.
This tests theantenna’s ability to read the RFIDtest card. If unsuccessful, therewill be no
reaction from the reader. If you use a test card andthe ViVOpay reader is attached to the
ViVOpay Kiosk II Controller, a dummytransactioncan be tested. The transaction will not
be authorized and willcome backwith a response,but will at least test for end-to-end
connectivity.
Making aPurchase
After the transaction has been enteredonthe kiosk control panel, the customer should
present their card/fob/phone in close proximity so that maximum surfacearea is
parallel to the antenna.
A single beep and all fourLEDs briefly flashing indicates the card/fob/phone has
been readcorrectly.
Installation Points
The ViVOpayKiosk II is designed to bemounted on ametal surface and in close
proximity to any internal motors and electrical devices that may beoperating inside
the kiosk. However, the ViVOpay Kiosk IIis susceptible to RF andelectromagnetic
interference. It is importantthat the unit not be mounted near(within3 or 4 feet) large
electric motors, computerUPS systems,microwave transmitters, anti-theft devices,
radio transmitters, communications equipment and so on.
Close proximity of metal tothe RF-emitting end of theantenna can greatly reduce the
range of the antenna. See the precautions describedin
FlushMounting the Kiosk
IIAntenna.
Tie all cablesneatly with nylon cable-tiesand route them so that they are
inaccessibleand invisible to customers.Label thecable ends, host,ViVOpay, and
power, to simplify connection testing or component replacement.
