IDS LCD Digital Keypad, Руководство пользователя, Страница: 28 / 32

28
IDS LCD Keypad User Manual 700-292-01C Issued March 2009
13. Changing a Partition
To change partitions the keypad must be assigned to access the required partition.
1.
Hold [MODE] until the keypad beeps.
2.
Press [1] [*].
3.
When prompted by the display to 'Select Partition' press [partition number] [*]
The keypads may be partitioned to remain in the new partition. Any value outside of these constraints will
result in a key entry error occurring.
Feature IDS 816 IDS 1224 IDS 1632
Partition 1 - 2 1 - 4 1 - 8
Zone 1 - 16 1 - 24 1 -32
Output 1 - 7 1 - 10 1 - 12
Doors 0 0 1 - 14
1 4 . Remote Telephone Access
Please note that this section is only relevant if programmed by your installer.
The IDS Alarm Panels have a secure, remote telephone interface which allows a user to arm/disarm, to
bypass/un-bypass zones and to set programmable outputs via a phone line. A user accesses the remote
dial-in interface by dialling the Alarm Panel using a DTMF phone.
To access the remote dial-in interface, dial the Alarm Panel, and wait the number of rings programmed
(the default number of rings being 15). If the fax defeat function has been enabled, dial the panel and
hang up after one ring. Dial in again within 1 minute, the panel will pick up immediately and transmit
handshake tones consisting of a high pitch tone for two seconds followed by a lower pitch tone for one
second.
Within twenty seconds of the panel transmitting the handshake tones, enter a valid user code on the
DTMF enabled phone. If a user code is not entered or if the user code is invalid - the panel will release
the line. If the user code is valid and telephone access has been enabled, the panel will give a single
confirmation beep indicating that the user has gained access to the remote interface. If no key-presses
are detected for twenty seconds once access has been gained to the remote interface the panel will
release the line.
Should the panel be programmed to report to your cellular telephone, entering the user code in the delay
between beeps will also allow access to the remote telephone interface.
If the phone in access has been setup to arm/disarm only, pressing the number of the partition allows the
user to toggle the panels arm status.
A single beep indicates that the partition has armed; a double beep indicates that the partition has
disarmed. 3 beeps indicate that the partition is not ready to arm.
If the phone in access has been set up to access the full menu, please refer to the table 5 and select the
required operation.