IDS LCD Digital Keypad, Руководство пользователя, Страница: 27 / 32

27
IDS LCD Keypad User Manual 700-292-01C Issued March 2009
11.2 How to Cancel Chime Zones
HOLD [2] + [ZONE NUMBER] + [*] + [#]
1.
Hold down the [2] key until the keypad buzzer sounds.
2.
The LCD display will indicate that you are in chime mode.
3.
To cancel any chime zones, press the key corresponding to that zone followed by the [ * ] key.
Alternatively use the [PANIC] or [MED] keys to scroll through the zones.
4.
An [N] alongside the zone number indicates that the chime zone has been cancelled.
5.
Repeat step 3 until all the required chime zones have been cancelled.
6.
Press the [#] key to exit the chime programming mode.
12. Viewing Trouble Conditions
(Hold down the [7] key for two seconds until the keypad buzzer sounds)
The user is alerted to a trouble condition via a flashing power LED. It is also possible to enable a trouble
beep. If the trouble beep has been enabled, the keypad buzzer will sound to alert the user that a trouble
condition has occurred. Press the [#] key to silence the buzzer. Hold down the [7] key for two seconds.
The ARM LED will flash. The system will automatically exit the TROUBLE VIEWING MODE after one
minute. Alternately to exit this mode press [#] .
NOTE:
Certain trouble conditions will only clear once the trouble condition has restored. To cancel the beeping
without viewing the trouble conditions, press [#] key.
Table 5 : Trouble Conditions
Indicator Trouble Condition
1 AC Mains Failure
2 Failure to communicate successfully to monitoring company
3 Phone line trouble
4 Siren tamper
5 Low battery
6 Loss of Clock Timer
7 Engineer Reset
8 Box tamper
9 Keypad 12V trouble
10 Tamper on peripheral device
11 Communication loss to peripheral device
12 Loss of power to peripheral devices
13 Reserved
14 SIM PIN Error
15 GSM Modem Error