IDROBASE Adi, Руководство по эксплуатации и обслуживанию

Страница: 14 / 32

14
D
5.7 INSTALLATION AND CONNECTION
The first operation to be done is to identify the environment where to install the PUMPING MODULE KIT, which
must be installed in a well-ventilated and sufficiently spacious place, positioning it 30 cm from the walls and which
complies with current regulations. In addition, the following supplies are required:
ELECTRIC CURRENT
• served by a socket connected to a general switch that can supply the Kilowatts and the voltage required by the chosen model,
protected by a differential switch (circuit breaker) and relative earth connection.
A
Switch
general
CURRENT
ELECTRIC
5.8 PUMPING MODULE INSTALLATION
1. Place the pumping module (C) in a well-ventilated and sufficiently spacious place, positioning it on the
floor, on the basis of the standards in force, taking care to prevent unauthorized persons from accessing it.
2. Connect the water supply kit (draft) (B) to the pumping module (C).
3. Connect the polyamide tube kit to the disinfection arch (A).
4. Connect the photocell kit (E) to the electrical panel of the pumping module.
5. Connect the pumping module (C) to the main switch of the electric current (D).
Switch
ON / OFF
plant start
C
B
Water supply kit
5 - UNPACKING AND INSTALLATION