IDK MSD-501, Руководство пользователя, Страница: 114 / 120

MSD-501/502/701/702 User
’s Guide
114
Problem Cause/Check item/Solution Page
Light shadows appear
on fine lines of video
from an analog input
PC.
Adjust the tracking. 49
Fluctuation appears on
the analog input video.
Adjust the tracking. 49
Automatic
measurement of input
timing fails.
In order to enable this menu, the input video must have 25% or more
brightness and its edges (all sides) need to be in contact with the
circumscribed rectangle in the effective display area.
45
Video is reduced
vertically or
horizontally.
Do the selected aspect ratio of the output resolution and that of the
connected sink device match? If not, set the aspect ratio of the sink
device.
34
Check the set aspect ratio of the input signal. 34
Check the monitor setting of the source device
(such as 4:3, 16:9, letter box and the like).
-
For analog input, signal that cannot be recognized by the MSD and
wrong aspect ratio may be applied. Perform the automatic
measurement in the
“NEXT ASPECT” mode.
45
Video flickers. If interlace signal is input to a sink device that does not support
interlace signal, the video may blink. Check the output resolution of
the sink device.
33
PC’s dual monitor
cannot be set or the
setting is canceled.
If the monitoring function for no-signal input works, the dual monitor
function may not operate correctly. In this case, turn the monitoring
function
“OFF”.
41
It takes a long time to
output video after video
input is switched.
If you set the HDCP output to
“HDCP INPUT ONLY”, some sink
devices may fail HDCP authentication. In this case, it may
temporarily not output video and audio when a channel signal without
HDCP support is input and then is switched to a channel signal with
HDCP support is input. In this case, set the HDCP output setting to
“ALWAYS”.
52
Video from a PC of
analog input is
displayed with bright-
and- dark vertical
stripes
Set the total number of horizontal dots.
If you change the total number of horizontal dots, you may
sometimes have to set the start position of scanning and the active
area.
47
Light shadows appear
on fine lines of video
from an analog input
PC.
Adjust the tracking. 49
Fluctuation appears on
the analog input video.
Adjust the tracking. 49
Automatic
measurement of input
timing fails.
In order to enable this menu, the input video must have 25% or more
brightness and its edges (all sides) need to be in contact with the
circumscribed rectangle in the effective display area.
45
Display position of
analog input video
changes on its own.
If the function that automatically adjusts the display position (upper
left of the screen) works by automatic measurement, the video may
move on its own. In this case, disable the adjusting position function.
48