MSD-501/502/701/702 User
’s Guide
52
7.8.7 Wipe color
Menu Top
→
OUTPUT SETTING
→
WIPE COLOR
Setting for Each output (COMMON TO OUTA AND OUTB)
Setting value R / G / B: 0 to 255 [Default]: R / G / B: 0 (black)
You can set the wipe color while switching video input when the input channel is switched.
If
you set “LINK” to “ON”, you can set only Red (R). Settings of Green (G) and Blue (B) will also be changed
according to the settings of the Red (R).
7.8.8 Video output connector
Menu Top
→
OUTPUT SETTING
→
OUTPUT CONNECTOR
Setting for Each output (each OUTA / OUTB)
Setting value ON [Default], OFF
The MSD outputs the same video to HDMI output connector and digital signal output connector (for
extension), and you can select ON/OFF for each connector. If you set one of them to
“OFF”, you can check
the video in the other output (simplified preview function).
7.8.9 HDCP output
Menu Top
→
OUTPUT SETTING
→
HDCP OUTPUT MODE
Setting for Each output (each OUTA / OUTB)
Setting value ALWAYS
: HDCP is output at all time. [Default]
DISABLE
: HDCP is not authorized (only video and audio without HDCP are
output)
HDCP INPUT ONLY
: HDCP is output only if input signal has HDCP.
You can set the HDCP output for when a sink device supporting HDCP is connected.
Normally set this menu to
“ALWAYS”.
Notes:
● For “HDCP INPUT ONLY”, some sink devices may not output video or audio temporarily due to failure of
the HDCP authentication when HDCP is switched from OFF to ON.
● When a sink device without HDCP is connected, only video and audio without HDCP are output regardless
of the setting of this menu.
