MSD-501/502/701/702 User
’s Guide
47
7.7.2 The total number of horizontal dots
Menu Top
→
INPUT TIMING
→
H TOTAL DOTS
Setting for Each input/input signal
Setting value 400DOT to 4125DOT (sampling block must be within 13 MHz to 162 MHz)
[Default] varies depending on the input signal.
You can set the total number of horizontal dots of analog RGB/analog YPbPr input video.
If other signal is input, the total number only can be displayed but not set.
7.7.3 Start position
Menu Top
→
INPUT TIMING
→
H START (Horizontal) / V START (Vertical)
Setting for Each input/input signal
Setting value
Function
Setting value
Horizontal start position
64DOT to 2900DOT (The total number of horizontal dots
-
Horizontal
active area or less)
Vertical start position
10LINE to 2048LINE (The total number of vertical lines
-
Vertical active
area or less)
[Default] varies depending on the input signal.
You can set the horizontal/vertical starting position.
Setting value must be as follows. If the set value exceeds the value, the starting position will be set the limit
value within the settable range automatically.
Horizontal : The total number of horizontal dots > Horizontal active area > Horizontal starting position
Vertical
: The total number of vertical lines > Vertical active area > Vertical starting position
7.7.4 Active area
Menu Top
→
INPUT TIMING
→
H DISPLAY (Horizontal) / V DISPLAY (Vertical)
Setting for Each input/input signal
Setting value
Function
Setting value
Horizontal active area
64DOT to 2900DOT (The total number of horizontal dots
-
64 or less)
Vertical active area
10LINE to 2048LINE (The total number of vertical lines
-
10 or less)
[Default] varies depending on the input signal.
You can set the horizontal/vertical active area of input video.
The horizontal setting value must be [The total number of horizontal dots > Horizontal active area]. If the set
value exceeds the limit value by changing the total number of horizontal dots, the horizontal active area will be
set to the limit value within the set range automatically.