HDC-TH200 User Guide/Command Guide
51
8.5.9 [ F48 ] Starting position of vertical lines
You can set starting position of vertical lines for analog video input.
Setting value
10 to 2048 : 10 lines to 2048 lines
Setting range is limited by vertical display start position, display period of vertical lines, and vertical sync
signal width.
Maximum setting value is “vertical display start po display period of vertical lines”
Minimum setting value is “vertical sync signal width +1”.
【
See: 8.5.11 [ F50 ] Vertical start position
【
See: 8.5.12 [ F51 ] Display period of vertical lines
【
See: 8.5.13 [ F52 ] Vertical sync signal width
Notes:
・
When you change this setting by using “ + ” and “ - ” buttons the LED blinks. During the LED is blinking,
press
“SET” button and changes are executed.
If you do not operate more than 10 seconds during the LDE blinking, changes are not executed.
・
If there is no analog
signal, it shows “- - -” and cannot change settings.
8.5.10 [ F49 ] Vertical active area
You can set vertical active area for analog signal.
Setting value
10 to 2048 : 10 lines to 2048 lines
Setting range is limited by display period of vertical lines.
Maximum setting value is “display period of vertical lines”
【
See: 8.5.12 [ F51 ] Display period of vertical lines
Notes:
・
When you change this setting by using “ + ” and “ - ” buttons the LED blinks. During the LED is blinking,
press
“SET” button and changes are executed.
If you do not operate more than 10 seconds during the LDE blinking, changes are not executed.
・
If there is no analog
signal, it shows “- - -” and cannot change settings.
