Part 2 - Configuration
62
Face Detection
When face detection event occurs in the selected
camera, the area that the face is detected displays on
the screen.
●
No.
: Select which cameras to apply Face Detection to.
●
Sensitivity
: Set sensitivity settings between 1 (Low)
and 5 (High).
●
Max. Detect Count
: Set the maximum detected
number of face as 8 or 32.
When you set the Max. Detect Count as 32, the
sensitivity feature will be disabled.
●
Min. Face Size
: Select 120 x 120, 150 x 150, 180 x180,
210 x 210 or 240 x 240.
●
Actions
: Specify which actions to take when a Face
Detection event occurs.
–
Record
: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to
Event
or
Time & Event
mode, the selected
cameras will begin linked recording when an event
occurs.
–
Alarm-Out
: Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
–
Notify
: Configure to be notified of events by Mail,
LAN1 through 5, SNS, Push, and/or Alert Window.
–
EventUpload:
Uploads the video clips when an
event occurs.
–
PTZ
: Moves the PTZ camera to a specific preset
position when an event occurs.
–
Event Monitoring:
Selects the cameras to monitor
when an event occurs.
•
In order to use the Callback feature, the NVR
must be registered on the remote program.
•
In case of the camera that not supports face
detection event, the face detection feature will
be disabled.
●
Ignoring Interval
: The system does not produce
event log entries or issue remote notifications
regarding face detected for the time specified
after the initial motion was detected. Set the value
between 1 sec and 5 secs or choose
Never
.
