Part 2 - Configuration
56
Disk
S.M.A.R.T.
Monitors disks that support
S.M.A.R.T. and notifies the user if a
disk error is detected.
Disk Config
Change
It will be highlighted when the NVR
reboots after the hard disk drive has
been replaced.
No Storage
Found
It will be highlighted when no hard
disk drive has been connected.
Consecutive
Invalid PW
It will be highlighted when login
fails by entering a wrong password
for consecutive attempts.
•
For system events, only an e-mail notification of
actions can be selected.
•
In order to use the Notify(Callback) feature, the
NVR must be registered to the remote program on
the receiving PC's end.
Camera System
A list of events that occur in the camera except for video
analysis.
Camera System_Video Loss
●
Activation Time
: Specify how long video loss has
to last in order for it to be considered as an event.
When the video loss is not detected for the specified
duration of time, it will not be considered as an event.
●
Actions
: Specify which actions to take when a Video
Loss event occurs.
–
Record
: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to
Event
or
Time & Event
mode, the selected
cameras will begin linked recording when an event
occurs.
–
Notify
: Configure to be notified of events by Mail,
LAN1 through 5, Push, and/or Alert Window.
–
PTZ
: Moves the PTZ camera to a specific preset
position when an event occurs.
–
Event Monitoring:
Selects the cameras to monitor
when an event occurs.
In order to use the Callback feature, the NVR must be
registered on the remote program.
●
Ignoring Interval
: The system does not produce
event log entries or issue remote notifications for
video loss detected for the time specified after the
initial video loss was detected. Set the value between
0.1 and 15 seconds or choose
Never
. This is supported
only when video encoders are connected.
●
Use Ignoring Time
: Select
Time Setup
to specify
the time to ignore video loss detection. Video loss
detection will be disabled for a specified time period.
This is supported only when video encoders are
connected.
